9、Ninth step: Checking the Printing head
Printing Head Normal
Printing testing normal，Begin to
print
Printing Head printing Break
Printing Break，Clear the printer
head
Enter Printer service
If there shows any breaks (maybe it caused by air bubbles in the printing head), please
clean your printing head. If it is still shown little breaks, especially only for one color, it is
unnecessary to repeatedly clean printer-head. Just keep the printer unuse for about one
hour, If it is still abnormal, please kindly contact local dealer.
Reset Procedure:
If the indicator light flashing when printing, it tells that you need to reset the chip to full
status. Please turn off your printer for about 1 minutes and switch it back on. Ink meter bar
shall show full ink. You can start printing as usual.
Refill Ink:
Please pay attention to the ink level in the reservoirs; if the ink level is below 1CM as the
above picture shown, please use refill kits to fill ink into Reservoir bottles. Carefully pull out