Epson Stylus CX4400 Series
1.Make sure the CX4400 Series is on and the red B ink light is on but not flashing.
2.Open the scanner and make sure its support locks in place.
4.Press the y Stop button again.
❏If another cartridge is low or expended, it moves to the _ position. Press the y Stop button again to see if more cartridges are low or expended.
❏If no other cartridges are low or expended, the print head moves to the replacement position.
Caution:
Do not touch any area shown below.
3.Press the y Stop button. The print head moves to the _ position to indicate which cartridge is low or expended.
5. Open the cartridge cover.
6.Squeeze the tab on the cartridge and lift it straight out. Dispose of it carefully. Do not take the used cartridge apart or try to refill it.
Note:
Do not move the print head by hand; this may damage the CX4400 Always press and release the y Stop button to move it.
Warning:
If ink gets on your hands, wash them thoroughly with soap and water. If ink gets into your eyes, flush them immediately with water. Keep ink cartridges out of the reach of children.
5/07 | 9 |