Copying Photographs

Select settings Make more than one copy

Menu

Return to menu or cancel job

Color copy

Select menus

Use the or Menu button to select menus. Use the or button to select settings. Pressto display the settings you have selected.

1 Load special photo paper short edge first and glossy side (or whiter side) up, then slide the edge guide against the paper.

2 Place your photo face-down on the glass,

with the top in the upper left corner. Move your document about 0.1 inch from the top

and side edge so your entire photo is scanned.

3

Close the scanner lid.

 

4

Press

until you see Quality&Paper

 

Quality&Paper

 

displayed.

 

Plain Paper-Norm

5 Press the button until you see Matte Paper HW, Photo Paper, or PSGP Paper (Premium Semigloss Photo Paper), depending on which one you’re using.

6 If you want to automatically resize your photo

to fill the page, press until you see Reduce/Enlarge on the display. Then press the button to display Auto Fit Page.

Reduce/Enlarge Auto Fit Page

7

8

Press

to display your settings.

Photo Paper

1

 

 

Letter

Press theColor Copy button. Your photo is copied and printed.

For more information about using the buttons or printing and scanning from your computer, double-click the EPSON Information Center icon on your desktop (or in the Dock on Mac OS X).

Solving Problems

If the red Error light is on, check the message on the Stylus CX. Try turning the Stylus CX off and then back on. If your problem is listed here, try these suggestions. For more information, see your software Help

or your on-screenEPSON Information Center.

The Found New Hardware

Click Cancel and follow the steps in

Wizard appears on

section 7. Disconnect the Stylus CX

your screen.

before installing the software.

You see an error message when you try to print

or scan.

Make sure your Stylus CX is connected to your computer, plugged into a power source, and turned on.

The Stylus CXMake sure you remove the tape from the ink

doesn’t work.cartridge holder, as described in section 1. Turn the Stylus CX off and then on again.

Slide back the transportation lock under the lid to unlock the scanner. See section 2.

Make sure the ink cartridges are pushed all the way down.

Make sure you’re using the USB cable that came with your Stylus CX. Try connecting it to a different USB port on your computer.

Make sure your EPSON Stylus CX5200 software is installed correctly.

Paper is jammed, or Remove and reinsert paper. Load paper

doesn’t feed correctly short edge first, against the right side, then slide the edge guide against the paper. Make sure the output tray is open.