Caution: Make sure the USB cable fits securely into the slot. The USB connector may snap if the cable is not routed correctly in the slot and the scanner is closed with force.
Close the scanner carefully.
Note: If you see several New Hardware Wizard screens, click Cancel for each of these screens and disconnect your Stylus CX. You can’t install your software that way.
Insert your Stylus CX software CD-ROM in your CD-ROM or DVD drive.

6Install Software and

Connect to Your Computer

The software works with Windows® 98SE, Me, 2000, and XP, and Macintosh® OS 9.1.x to 9.2.x and 10.2.x to 10.3.x. Follow the steps below (for Windows), or the steps in the next column (for Macintosh).

Note: There is a Security Lock program on your software CD-ROM that lets you prevent unauthorized use of your CX6600. See the Quick Guide for instructions on installing and using it.

Windows

1 Make sure the Stylus CX is not connected to your computer, then turn on your computer.

2

3 Wait until you see this screen, then click Install.

Note: If you don’t see this screen, do the following:

For Windows XP: click Start >

My Computer. Then double-click the Epson CD-ROM icon.

For Windows 98/Me/2000: double-click My Computer.

Then double-click the Epson CD-ROM icon.

4 Read the license agreement, then click Agree. Several messages display on your screen.

5 When you see this screen, make sure your Stylus CX is turned on, then lift up the scanner.

6 Remove the yellow sticker and plug the square end of the USB cable into the USB port on your Stylus CX. Then route the cable in the slot as shown.

7

8 Plug the flat end of the cable into any available USB port on your computer.

9 Click Next and follow the instructions on the screen to install more software.

Note: It will take several minutes to install the software.

Don’t cancel the installation.

10 At the completion screen, print a test page, if desired. When done,

click Next to install additional software.

continue