B

Turn on Power On Protect.

(1) Select Power On Protect, and then press the [Enter] button.
(2) Select On, and then press the [Enter] button.
(3) Press the [Esc] button.
C

Turn on User's Logo Protect.

(1) Select User's Logo Protect, and then press the [Enter] button.
(2) Select On, and then press the [Enter] button.
(3) Press the [Esc] button.
D

Set the Password.

(1) Select Password, and then press the [Enter] button.
(2) The message "Change the password?" is displayed, select Yes and then
press the [Enter] button. The default setting for the Password is "0000".
Change this to your own desired Password. If you select No, the screen
shown in step 1 is displayed again.
(3) While holding down the [Num] button, enter a four digit number using
the numeric buttons. The number entered is displayed as "* * * *". When
you enter the fourth digit, the confirmation screen is displayed.
Remote Control
(4) Re-enter the Password.
The message "Password accepted." is displayed.
If you enter the Password incorrectly, a message is displayed prompting
you to re-enter the password.
Entering the Password

When the Password entry screen is displayed, enter the Password using

the numeric buttons on the Remote Control.

Procedure

While holding down the [Num] button, enter the Password by

pressing the numeric buttons.

When you enter the correct Password, projection begins.

Attention
•
If an incorrect password is entered three times in succession, the message
"The projector's operation will be locked." is displayed for about five
minutes, and then the projector switches to standby mode. If this happens,
disconnect the power plug from the electrical outlet and then reinsert it
and turn the projector's power back on. The projector displays the
Password entry screen again so that you can enter the correct Password.
•
If you have forgotten the password, make a note of the "Request Code:
xxxxx" number that appears on the screen and contact the nearest address
provided in the Support and Service Guide.
s
Epson Projector Contact
List
•
If you continue to repeat the above operation and input the wrong
Password thirty times in succession, the following message is displayed and
the projector does not accept any more Password entries."The projector's
operation will be locked. Contact Epson as described in your
documentation."
s
Epson Projector Contact List
Security Functions
38