62
When lights on redError : lit : flashing : off
Internal failure
Wait for approximately 1 minute and 30 seconds.
Then, disconnect and reconnect the power cable.
If the indicator status does not change when
is pressed and the power turned on...
Fan related error/Sensor error
High temperature error
(overheating)
The lamp turns off automatically and
projection stops. Wait for approximately 5
minutes. When the Power indicator color
changes to orange, check for the 3 points
shown at right.
•Move this unit away
from the wall by at
least 20 cm.
•Clean the air filter.
sp. 66
•When using this unit
at high altitudes, that
is 1500 m or more
above sea level, set
“High Altitude Mode”
to “On”. sp. 59
If the indicator status
does not change when
is pressed and the
power turned on...
Lamp error/Lamp failure/Lamp cuts out
Wait for approximately 1 minute and 30 seconds, and check for a blown lamp. sp. 69
Clean the air filter and the air intake vent. sp. 66
The lamp is not broken
Reinsert the lamp then turn on the main
power switch on the main unit.
If the condition is not
fixed once the lamp is
re-inserted
The lamp is broken Contact your dealer for furth er advice. sp. 80
When using this unit at high altitudes, that is 1500 m or more above sea level, set “High Altitude Mode”
to “On”. sp. 59
Auto Iris Error
Power Err. (Ballast)
Red
Red
Red Disconnect the power cable from the electrical
outlet and contact your dealer.
If the error continues
Wait for approximately 1 minute and 30
seconds. Then, disconnect the power cable
from the electrical outlet and contact your local
dealer or the nearest address provided in the
Inquiries. sp. 80
Red
Red
Red
Red
Red
Red
Red
Red
Red