result in the Panamorph anamorphic lens being below the center of the projector lens and tilted slightly downward. Tighten the knobs.

c.Adjust the rotation of the Transport about the Pivot Screw so that the left and right sides of the image are an equal distance from their respective screen borders. Now tighten the Pivot Screw and the four #6 screws holding the Transport to the Attachment Plate.

d.For optimum multiple aspect ratio performance, adjust the projector’s zoom so that a 1.85:1 aspect ratio movie (Panamorph anamorphic lens “out”) is just masked by the top and bottom of the screen border. This way 1.85:1, 16:9 and 2.35-2.4:1 aspect ratio movies should all be presented to fill the screen at a constant height.

Note: If you use lens zoom while projecting in anamorphic mode, you may observe a slight image distortion and reduced brightness. To minimize these effects, place the projector at the recommended distance from the screen, as listed in your projector manual. This will lessen the need to use lens zoom.

CLEANING

In most applications lenses do not need very much cleaning – a bit of dust will not impact image clarity. However, in today’s high performance home cinemas with very dark rooms a small build-up of dust or other foreign matter on the projector lens or Panamorph anamorphic lens can degrade image quality. Clean the lens whenever you notice dust or dirt on the surface. Use a blower brush designed for camera equipment to remove dust from the lens. To remove dirt or smears use a lens cloth or tissue. If necessary, moisten the cloth with lens cleaner and gently wipe the lens surface. CAUTION: Never rub the lens with abrasive materials. Use only lens cleaning fluids designed for cleaning optics.

If there is any residue or build-up on the anamorphic lens then it is recommended that you clean the optics while the anamorphic lens is in front of the lit beam of the projector. This will allow you to quickly see both the results of cleaning and also if you are causing any damage.

ELPALK2 ATTACHMENT KIT COMPONENTS

 

ITEM

QTY

Attachment Plate

1

5/8” long plastic spacer

5

M4x30mm screw

5

M4 flat washer

5

M4 lock washer

5

#10-24x7/8” socket head screw

6

3/8” long aluminum spacer

6

1/8” Gold hex key

1

#6-32x3/8” screw

4

#10-32x5/8” screw

1

#10-32 nut

1

#10-32 lock washer

1

#10-32 flat washer

1

Instructions

1

Page 4