7
English
Assembly and Installation
Make sure to follow the steps below to install the mount. If you ignore these steps, the mount could fall down and could cause
personal injury or property damage.

1. Installing the wall plate to the wall

Fit the wall plate to the wall using M8 × 50 mm anchor (more than 3 pcs.) or 8 × 80 mm lag bolt (more than 3 pcs.).
Set the horizontal center of the wall plate 8 cm (3.1 in.) left from the horizontal center of the whiteboard. See the
illustration below. Allow at least 6 cm (2.4 in.) space between the top of the whiteboard and the bottom of the wall plate. If
the 16:9 of maximum distance (tele) screen size is used, refer to the table in the previous page.
You can slide projector horizontally 4.5 cm (1.8 in.) after installing. See step 7 on page 10 for details.
Insert the anchor or lag bolt into the place as shown below. Insert the anchors or lag bolts at least three points.
If you insert at four points, use four point As or four point Bs as shown below.
The combined mass of this mount and the projector is approximately 13 kg (29 lb) at maximum. Before starting
the installation, carefully check the construction, material, and strength of the wall and use the mo st appropriate
methods to install.
Horizontal center of the whiteboard
Horizontal center of the wall plate
5 cm (2.0 in.)
8 cm (3.1 in.)
A
B
B
B
B
A
A
A
A
B
B
B
B
A
A
A
Four points mounting Three points mounting
❏When you set the projector on the wall with this mount, the wall requires enough strength to hold the
projector and this mount. A wall of reinforced concrete or steel skeleton construction is recommended.
Confirm the mass of the projector and the mount, and keep the strength of the wall. If the wall does not
have enough strength, reinforce the wall before installing.
❏Install the mount firmly to hold the mass of the projector and the mount, and to resist horizontal vibration.
Use M8 nuts and bolts. Nuts and bolts smaller than M8 could cause the mount to fall.
❏Epson takes no responsibility for any damage or injury caused by incorrect installing.
Warning