59
Problem and Alarm Display Indicator Point:
•If the indicator is norma l but you experience problems with video projection, refer to
"When Indicators Do Not Help" on the following page.
•If the indicator disp la y status is not shown in this table, consult your vendor.
Indicator
Status Cause Remedy or Status See
Page
Steady red High
internal
temperature
The usage temperature range of the projector is
5°C–35°C, and the projector should be used in this
range. 77
Place the projector in a well-ventilated location
where air intake and exhaust vents are not blocked. 18
Clean the air intake vent. 67
While the indicator is red, turn off the lamp to lower
the internal temperature of the projector . -
Flashing
red
(1-second
intervals)
Problem
with lamp Replace with new lamp.
Model No: ELPLP13 68
If the lamp is broken, handle pieces carefully to
avoid injury, and consult an Epson Service Center
for repair (video cannot be projected until the lamp
is replaced).
-
If the lamp or lamp cover is not attached securely,
follow the replacement instructions to attach it
securely. 68
Flashing
red
(2-second
intervals)
Internal
problem Stop using the projector, pull the plug from the
outlet, and consult your vendor or an Epson Service
Center (listed at the end of this manual) for repair. -
Flashing
orange High-speed
cooling in
progress
Not a problem, but projection will be interrupted
automatically to prevent further temperature rise. -
The usage temperature range of the projector is
5°C–35°C, and the projector should be used in this
range. 77
Place the projector in a well-ventilated location
where air intake and exhaust vents are not blocked. 18
Clean the air intake vent. 67