Frequency
Source
V ---.--Hz
Reset Lamp Timer
H ---.--kHz
Lamp 1900H
SYNC Mode
SYNC Polarity
------
H ------
Resolution
Refresh Rate 0.0 Hz
0x 0
Computer
Input Signal Analog-RGB
Execute
:
:
:
:
:
:
V ------
:
:
:
:
Reset Lamp Timer
Execute?
YES NO
Connecting to a
computer
If the source is connected to the
[Computer] port or [DVI] port,
the audio signals will be output
according to the "Computer/DVI
Audio Input" setting in the
"Audio" menu.
Be sure to turn the power for all components off before
making any of the following connections.
User's Guide "Connecting to a Computer"
"Connecting to a Video Source"
User's Guide
"Screen Size and
Projection Distance"
Connections
Set up the projector so that the distance from the screen to the projector's lens is 77–1113 cm.
The shorter the distance between the two, the smaller will be the images, and the greater the
distance, the larger will be the images. Adjust the distance in accordance with the size of the
screen. If using an optional lens, refer to the documentation for the lens.
Setup
The [Audio] port to use is
the port that is in the same
box as the port being used
to input the video signals.
DVI-D/DVI-D
digital video cable
or DVI-D/DFP
digital video cable
(optional)
VGA-HD15/BNC
PC cable
(optional)
Computer cable or
VGA-HD15
PC cable
(accessory or optional)
To computer's monitor
output port
(Mini D-Sub 15-pin)
To computer's monitor
output port
(DVI-D or DFP)
RCA audio
cable
(accessory)
To computer's
audio output port
To computer's
audio output port
Audio cable
(accessory)