EPL-7500 LASER PRINTER

Installation/Support Tips

Software

PostScript Mode

For PC users: choose EPL-7500 from the printer selection menu in the application program. If the menu does not list EPL-7500, choose any PostScript printer.

For Macintosh users: check your Macintosh documentation for instructions on installing a printer. lf the EPL-7500 is not listed among the printer options, choose the LaserWriter.

HP Emulation Mode

1.lf the application program does not support the PostScript language, or if the program was written specifically for the HP LaserJet, then configure the printer to HP emulation mode. Then choose the first printer available in the list below from the application program’s printer selection menu.

HP LaserJet series IIP

HP LaserJet series II

HP LaserJet +

HP LaserJet 500

HP LaserJet

Set Up

The EPL-7500 is factory-set for the parallel interface. To use another interface, you must change the INTERFACE setting in SelecType level 2 and save the new setting. After changing and saving the setting, turn off the printer before attaching the Interface cable, or the printer could be damaged.

If an AppleTalk cable is connected, never operate the printer with the SelecType INTERFACE option set to any other interface. Failure to use the AppleTalk setting may leave the printer inoperable or bring down the entire system.

To print complex pages, it may be necessary to increase the printer’s amount of memory by adding a memory board.

EPL-7500-10

1/7/91

Laser Printers