Setting Up the Scanner

Follow the steps below to set up the scanner and connect it to the SCSI port on your Macintosh or to another SCSI device.

The SCSI cable included with the scanner has a 25-pin connector on one end and a dual 25-/50-pin connector on the other.

50-pin connector for an additional device

25-pin connector to the scanner

1.Take the scanner out of its box and place it on a flat, stable surface with the rear panel facing you.

2.Remove the tape securing the scanner cover and pull out any packing material from underneath the cover.

3.Turn off your Macintosh, scanner, and any other peripheral devices. The scanner is turned off when the O side of the power switch on the rear panel is pressed down.

Caution:

c Be sure that your Macintosh, scanner, and any other peripheral devices are turned off before you plug in any cables.

4.The scanner’s default SCSI ID setting is 2. If you need to change the scanner to another SCSI ID, press the plus or minus button next to the SCSI port until you see the desired number in the display. (Be sure you do not select a number assigned to another device.)

3Getting Started