Epson LP47P1 Inserting the Remote Control, Batteries, Installing the Printer Ink Cassette, 12 Flip up the lock cover, 10Slide in the printer until it stops

1 Press in on the top of the battery cover on the back of the remote control. Then slide the cover down and off the remote.

2 Insert the batteries as shown here, making sure the + and – ends face the right way. Then push them down flat.

3 Place the cover into the grooves and slide the cover all the way up until it clicks into place.

1Press and release the printer cover latch to open the cover.

2Flip down the printer lock cover and turn the lock counterclockwise to loosen it. It spins freely when it is unlocked.

3Grasp the printer handle and pull the printer out as far as it goes.4Pull open the ink cover on the side of the printer.

5Remove the cassette from its package. Then remove the red paper strip from the end.

6If the ink ribbon is slack, rotate the spindles to tighten it.7Position the cassette as shown below, on the right.

Pointed plastic tab should face up

Covered ends of the ribbon should face out

8Carefully align the cassette and its ribbon with the slot, then gentlypush in the cassette until it clicks into place beneath the latch.

Caution

You must align the cassette and its ribbon with the slot or you will damage it when you slide it in.

9 Flip up the ink cover and push it closed.10Slide in the printer until it stops.

11 Push in on the printer lock as you turn it clockwise to tighten it. If it doesn’t tighten, push the printer in further and try again.

12 Flip up the lock cover.

Caution

Make sure to lock the printer securely and close the lock cover completely or the printer won’t print.