User’s Manual
Where to place the printer
WARNING!
The
Connections
It is possible to connect up to three cables to the printer. All connections are placed at the back of the printer (there can be different connections depending on the configuration of the Printer Interface Board).
18.Plugging in the Power Adapter
Verify On/Off Switch and make sure the printer is turned off. Connect the Power Supply DC Cable to the Printer DC Connector. Make sure the plug is locked.
Connect the Power Cord to the Power Supply AC Connector and to an electrical outlet. This outlet must have its ground pin connected as shown on the right.
The Power Supply LED must be on.
Turn on the printer using the On/Off Switch, located on the left side of the printer, and check if the Power ON LED is lit. The
printer will initialize and indicate the printer status (
).
WARNING!
Assure that you use the Bematech +24V @ 2.5A Power Supply or an equivalent model fulfilling UL, CE and FCC norms and that the connector has a ground pin. The usage of a wrong power supply can cause fire or electrical shock.
CAUTION!
Make sure the power supply is not connected to the power outlet when you connect or disconnect the DC connection! Otherwise this can cause damages to the printer or the supply. Make sure the printer is connected to a proper ground through the power supply. This will avoid the incidence of static discharges and will protect electrical components inside the printer. If the printer is not correctly grounded, damage to the printer may occur.
14
