6.2Select Graphics Mode “ESC (G nL nH m”
Format: |
|
|
|
|
|
|
ASCII | ESC | ( | G | nL | nH | m |
Hex | 1B | 28 | 47 | nL | nH | m |
Decimal | 27 | 40 | 71 | nL | nH | m |
Range of Definition:
nL=01H, nH=00H m=01H or 31H
Function:
-Shifts to graphics mode.
-If m has any value other than the above, this command is ignored.
-Printing of lines up to the present line is started, and the printer waits until the printing is completed.
-The various settings are the same as when the power is turned on.
-The page management coordinate system and the position management coordinate system are set by taking the printing position in the Y direction at the time of setting as the origin upon the
-The printing position in the X direction is set to the origin upon the
-The MicroWeave print mode selection command is effective.
Initial State:
The character mode.
Related Commands:
Commands related in the direction of applying an effect (Setting)
The character mode selection made by the ESC @ command is changed. Commands related in the direction of receiving an effect (Setting)
The graphics mode is canceled by the ESC @ command. Commands related in the direction of applying an effect (Operation)
Only the following commands are valid for Stylus Pro 7000 in Graphics
mode: |
|
|
|
LF | ESC (C | FF | CR |
ESC (U | ESC (V | ESC. | ESC (r |
ESC + | ESC (v | ESC @ | ESC H |
ESC (c | ESC $ | ESC (i | ESC r |
ESC (S | ESC U | ESC (e | ESC ( / |
ESC | ESC G |
|
|
Commands related in the direction of receiving an effect (Operation)
None
EPSON Imaging Technology Center | Page: 23 |
Revision: 1 (Date: 6/20/00) |
|