2.Verify that the battery is installed in the
3.Connect the AC adapter to the viewer, but do not power it on.
4.After the firmware file has been copied to the memory card, insert the CompactFlash or SD memory card into the viewer.
5.Press and hold down the “OK” and keys while sliding the “POWER” switch as shown below.
When you see the firmware update screen (see image below), release the OK and keys. Note: If you do not see this screen, power off the unit and start the firmware process again.
During the update process, the message screen will display the current firmware and updated firmware versions. Then the message “Updating Resources” will appear.
Important: Do not remove the battery or disconnect the AC adapter during the firmware update process.
6.The firmware update process is completed when you see this screen (see image below).
Page 3 of 4
PSB.2007.03.001