7.After a few moments, the display on the front of the unit should show Output=720P 60Hz.
If it does not, press the POWER button on the remote control to place the video processor in Setup Mode. (You see Setup Mode on the display.)
Press the Menu button. Then use the u and d buttons to select the output resolution setting (“OUT = xxx”). Use the l and r buttons to change the setting to OUT = 720p 60 Hz.
Press the POWER button on the remote control to return the video processor to On Mode.
8.Remove the protective lens pad from the projector, then remove the lens cap.
9.Plug in the power cord. Make sure batteries are installed in the projector remote control.
10.Turn on the power switch on the back of the projector, then press the On button on the remote control.
Turn on the projector
Power switch
2