Equator pmn owner manual Back View

IMPORTANT SAFETY INSTRUCTIONS

WARNING

When using your dishwasher, follow basic safety precautions

Read all instructions before using the dishwasher

Use the dishwasher only for its intended function

Use only detergents or wetting agents recommended for use in a dishwasher and keep them out of the reach of children.

SAVE THESE INSTRUCTIONS

WARNING

Instructions pertaining to a risk of fire, electric shock, or injury to persons.

Electrical Instructions:

An electrical supply of 110-120 volts AC only, 60Hz is required. Make sure that a suitable electrical supply socket is located close to where the dishwasher is to be placed. For your personal safety, the appliance must be grounded. The appliance is equipped with a power supply cord having a 3-prong grounding plug. To minimize possible shock hazards it must be plugged into a matching 3-prong grounding type electrical outlet.

Installation Instructions

1.Remove all packing materials carefully

2.The water inlet hose from the machine terminates in a 3/4” female connector. The water supply

should therefore terminate in a similar male connector and should have a stopcock close by in the pipe. It is recommended to connect the machine to hot water supply. Connect the straight connector of the inlet hose securely to the water supply . Connect the other end (bent connector) to the water inlet valve at the back of the dishwasher cabinet. Do not over-tighten to avoid damage to threads.

3.Prepare the drain hose so that it has a hooked end. Use the plastic U-bend fitting provided for this purpose. The end of the hose should be dropped into a drainage standpipe, the maximum height of which should be no more than 6” above the base of the dishwasher. To allow for an air gap around the end of the drain hoes, the diameter of the standpipe should be at least 1.2" (3cm). Connect the other end of the drain hose (L shaped) to the drain port connection at the back of the dishwasher cabinet. Tighten the drain hose to the drain port using the metal clip included in the package.

4.If you wish, you may connect the water inlet hose on to the kitchen sink tap. You must obtain correct fittings/adaptors to match the inlet hose connectors to ensure secure connection. However, permanent plumbing is recommended.

BACK VIEW

Drain

Connect	Inlet Valve
	Connector

5.If leaks are located, immediately turn the water supply off and check the connections fully. Tighten connections if necessary.

6.If for any reason you are unable to stop the leak yourself please seek advice from a qualified plumber.

7.The minimum height clearance required to install your dishwasher on a counter top surface with overhead cupboards is 17.8” (45cm).

8.Make sure there is an electrical power supply within easy reach of the machine. The power cord is 6 feet (182.8cm) long.

9.The dishwasher must be installed on a "solid" level surface.

To level the dishwasher, adjust the 4 level screws under the dishwasher. 4