CONTROLS (CONT’D)
MENU - Cont. ALARM ON/OFF: Press the MENU button until
"ALM ON" or "ALM OFF" appears in the display.
Press the CHANNEL/SEL + or - buttons until the
desired state is selected. (Note: This enables or
disables the external alarm, e.g. horn or lights.)
SQUELCH Press and hold "Scan" button, use "volume" up to
loosen squelch and down to tighten squelch.
SYS Momentary switch. The SYS (SYSTEM) button is
used to select system changes. System may be
incremented by pressing and releasing the SYS
button. Alternately, when the display shows the
System name, the CHANNEL/SEL buttons may be
used to increment or decrement the system selec-
tions. (NOTE: The radio may be programmed with
wrap around on the system selection; this would
allow the radio to switch from the highest to lowest
system with one change instead of ramping all the
way through the list.)
CHANNEL/SEL Ramp Switch. The CHANNEL/SEL button is
used to increment or decrement the current channel
selection. It is also used as described above to
increment/decrement the System. In conventional
mode, these buttons change the channel selection.
CLR Momentary switch. The CLR button is used to exit
from the menu operation, monitor a conventional
channel or end a special/individual call.
HOME/
EMERGENCY Momentary switch. The HOME or EMER-
GENCY button is used to select a home system, or
channel. The radio may be programmed to revert
to a particular system or channel within the se-
lected or home system. It may also be programmed
to send an emergency message (GESTAR) when
pressed and held for approximately one second
(either on the selected system or on the Home
system).
FLEX KEYS
A1, A2 The auxiliary buttons are used to access frequently
used menu selections quickly. They can also be
programmed as a HOME, External Alarm, Publi c
Address, T99 decode, Private, and Scan add/delete.
11