Essick Air D46 720 manual Replacing Evaporative Wicks, Operation

REPLACING EVAPORATIVE WICKS

8)Remove both bottles.

9)Depress both latches to remove grille and wicks.

10)Replace wicks and grille, latches will snap in place

11)Replace bottles to original position (See Figure B).

NOTE: Overfilling will result in water damage.

OPERATION

DESIRED

HUMIDITY

SETTING LOW - 1 DROP THROUGH HIGH- 4 DROPS

ACTUAL

HUMIDITY

READING

HUMIDITY

CONTROL

BUTTON

FAN SPEED

INDICATOR

LOW - 1

THROUGH

HIGH - 4

REFILL INDICATOR

POWER INDICATOR

%%

HUMIDITY	SPEED
PRESS TO SET	PRESS TO SET	FAN SPEED
RANGE 25% - 65%	HOLD FOR OFF	BUTTON

1)Plug cord into wall receptacle. Your humidifier is now ready for use. The humidifier should be placed at least FOUR inches away from any walls and away from heat registers. Unrestricted airflow into the unit will result in the best efficiency and performance.

2)The digital control allows you to use the low setting for the quietest operation or a high setting for maximum output.

3)For initial operation, push the speed button once for the sleep setting and continuously press the button to increase desired speed to the highest speed. TO STOP the unit, press the button for two seconds, or keep pressing button until display reads OFF.

4)To take advantage of the digital humidistat, press the speed button to any setting other than OFF. Then adjust the set humidity by using the up and down buttons. Humidity will increase in increments of 10%. When the room humidity level rises above the set humidity, the humidifier will stop. When the humidity level drops below the set humidity, the humidifier will turn on automatically.

5)The refill light will indicate when the unit is completely out of water in both bottles. The motor will also shut off. To refill, refer to Step 4 IMPORTANT FILLING INFORMATION.

NOTE: When excessive condensation exists, a lower speed setting is recommended.

CAUTION: Disconnect power before filling, cleaning or servicing unit. Keep grille dry at all times.

4