CELL PHONE DUMP CHARGING

MicrolinkFR170 OWNER’S MANUAL

CELL PHONE DUMP CHARGING

Because cell phone batteries vary in their current ratings, we cannot guarantee charging capabilities or usage time.

1.Set POWER/VOLUME control to OFF position.

2.Plug one port of the USB into your cell phone and the other port into <USB Cell Phone Charger> of the unit..

3.Set < FM/AM/WB Select Knob> to CELL position.

FM/AM/WB Selection Knob

USB Jack

NOTE: For crank-to-cell phone usage estimate, 10 to 15 minutes of cranking may result in 1 or more minutes of talk-time. It is important to turn the crank at least 2 revolutions per second, or until you see the green LED above the crank handle turn on. This is an indication that the phone is receiving enough power from the radio. Continue to crank at this rate until you are satisfied that an appropriate level of charge has been received by your cell phone. If you decide to stop cranking for whatever reason, please wait at least 5 seconds before beginning to crank again. Not following these instructions may cause damage to your cell phone for which Eton disclaims any liability and will not be held liable for any actual or consequential damages related to this matter.

Using The Light

Press the <Light> button (on the top of the unit) and the light will be on. Press the button again to turn off the light.

TURNING THE RADIO ON AND OFF

Turn it on with the OFF/VOLUME control.

To turn it off, set the OFF/VOLUME control to OFF.

6

Page 6
Image 6
Eton FR170 Cell Phone Dump Charging, Using The Light, Turning The Radio On And Off, Turn it on with the OFF/VOLUME control