Eton FR600 owner manual Battery Power, Solar Power, Dynamo Power, DC-IN 5V ADAPTOR not included

SOLARLINLK FR600 OWNER’S MANUAL

rubber covers. After applying power, select the correct position with the Power Supply Knob and place the Band Selecting Knob in the AM, FM, SW, WB or Alert position to turn it on. Turn it off by placing the Band Selecting Knob in the OFF position.

Note: The radio can be played while it’s charging.

BATTERY POWER

Open the battery compartment cover, you can find two groups of sockets for installing the batteries. One group of sockets is for the rechargeable Ni-MH batteries and the other group of sockets is for the AA batteries.

Install 3 AA batteries and set the power selector switch to the BATTERY position.

SOLAR POWER

When you’re in sunlight set the power switch to the SOLAR posi- tion. This position also recharges the Ni-MH rechargeable battery.

Note: The rechargeable Ni-MH batteries have been disconnect for transportation purposes. To use the crank-charge system, open the battery compartment cover and connect the recharge- able batteries’ plug into its socket.

DYNAMO POWER

The rechargeable Ni-MH (nickel-metal-hydride) battery is in the battery compartment. To use it plug the battery into the socket adjacent to it, then set the power switch to the DYNAMO position. You may have to charge the battery; to do this turn the crank for 90 seconds. The rechargeable battery will eventually lose its abil- ity to hold a charge.

6

SOLARLINLK FR600 OWNER’S MANUAL

DC-IN 5V ADAPTOR (not included)

This socket is located on the back of the radio, under the rubber plugs. Plug in the AC adapter to the DC IN 5 volt socket. This also charges the Ni-MH battery.

DC-IN USB COMPUTER SOCKET (USB cord not included) This socket is located on the back of the radio, under the rubber plugs. Plug in the USB cord to the DC IN socket. This also charges the Ni-MH battery.

VOLUME CONTROL

Turning the Volume Adjusting Knob (located on the lower right of the radio) clockwise turns up the volume; counterclockwise turns down the volume. Always turn down the volume before using earphones.

CHARGING CELL PHONES (cell phone charging cord in- cluded)

If you revolve the Power Supply Knob to the OFF/PHONE CHAR- GER position the radio will charge cell phones. Plug the cell phone charging cord into the USB PHONE CHARGER jack at the rear of the radio. Plug the cell phone charging adapter tip into the other end of the cord and then into the jack of the cell phone. Then put the radio in the sun or revolve the hand crank to charge the cell phone. About 10 minutes of cranking results in one or two short emergency calls.

NOTE: When charging a cell phone via the USB cell phone charger, it is important to turn the crank at least 2 revolutions per second, or until you see the green or orange LED above the crank handle

7