Assembly Instructions for the Hex Screen House:

You can usually assemble this screen house alone. However, with first time set-up or with windy conditions, you will need help.

Component List:

1 Screen/Body w/ Hub 1 Tent Bag 1 Pole Bag 6 Rafters 6 Poles 1 Stake Bag and Stakes

Layout the Parts

Unpack the tent bag, pole bag and separate all of the components. Choose a suitable place and unroll and unfold the fabric with the Eureka! label up.

Assemble all of the chain-corded poles and rafters. Check and make sure that each section is fully seated into the next. See fig.2.

Important: Locate the hub fitting attached to the center of the tent roof. Align the hub arms to match the layout of the corner pins without twisting the fabric. See fig.1.

fig.1

fig.2

Fit the Rafters

 

• Slide a rafter section labeled

 

"TOP" onto a hub arm.The

fig.3

spring clip must engage the

 

slot in the hub arm. Repeat

 

with the remaining until all

 

rafters are secured in place.

 

See fig.3.

 

• Make sure the hub and

 

fabric are still aligned.

 

Raise the Frame

Insert the corner ring & pin into the bottom section of a pole.

See fig.4. Then fit the top of the pole into the elbow of its coresponding rafter.

With a second pole, fit it into the diagonal opposite rafter and pin to form and arch. Lift the arch, and working your way

around the frame, attach the remaining poles to erect a free standing unit.

See fig. 5. fig.4

fig.5

Attach the Fabric to the Frame

Attach all of the top pole clips first. It may be necessary to open the doors and step inside the shelter to reach the clips. Then, attach all side clips. See fig.6.

Stake down all corner rings and your Screen House is ready. See fig.7.

fig.6

fig.7

Take down

Zip the door closed.

Unstake the screen house.

Unclip the fabric from the frame.

Remove the corner pins from the ends of the

poles and remove from the rafters.

Remove the rafters from the hub. Collapse the sections and store in the pole bag.

• Fold the fabric into thirds. Place the pole bag on the fabric and together, roll them up.

• Pack all components into the storage bag.

www.eurekatent.com

1.800.572.8822

REV E 10.09

Page 1
Image 1
Eureka! Tents Hex Screen House manual Component List, Layout the Parts, Fit the Rafters, Raise the Frame, Take down