Assembly Instructions for the Northern Breeze:
You can usually assemble this structure alone. However, with first time
Component List: |
|
| |
1 | Screen/Body w/ Hub 1 Tent Bag | 1 Pole Bag | |
4 | Tent Poles 3 Awning Poles | 1 Stake Bag W/ Stakes & Guy lines | |
1.Unpack the tent bag, pole bag and separate all of the components.
Unroll and unfold the fabric into a rough rectangle with the Eureka! label up.
2.Assemble all of the
3.Locate the spider hub fitting, in its bag, attached to the center of the roof. See fig.1& 2.
fig.1
fig.2
4.One end of each frame pole has a larger diameter. Slide this end onto one of the arms of the hub. Make sure that it seats securely. Improper fit can cause the hub to break. Slide another pole onto the opposite arm.
See fig.3.
fig.3fig.4
5.Check and make sure the hub and fabric are aligned.Then, insert the proper corner ring & pin into the bottom pole section. See fig.4.
REV B. 11.07
6.Raise and center the arch over the fabric and attach the remaining two poles to erect a free standing unit. See fig. 5.
fig.5
7. Attach the four center clips to the poles. See fig.6.
fig.6
fig.7 | fig.8 |
8.Attach the bungee cords to the corner hooks. Then attach all remaining clips. See fig.7 & 8.
9.Square up the tent and stake down all four corner loops. See fig.8.
fig.8
10.Tuck the ground skirts under the walls and into the tent.
Your Northern Breeze is ready. See fig.9.
fig.9
fig.10
11.The Northern Breeze features an awning over each door. Untie one of the awnings and assemble the three awning poles. The tall pole fits in the center grommet with the two shorter poles at the sides. Drive three stakes, each one pole length out from the tent, and attach a cord/slider to the awning loop at each pole and to its stake.
Adjust the slider for proper tension.
See fig.10.
The Northern Breeze also features an optional floor. Lay out the floor inside the tent and attach the tabs to the snaps on
the skirt. See fig.11
fig.11
