Eureka! Tents manual Assembly Instructions Scenic Pass XT Tents

ASSEMBLY INSTRUCTIONS

SCENIC PASS XT TENTS:

Component List:

1	Tent Body,	2 Tent Poles, 1 Tent Fly, 1 Carry Bag,
1	Pole Bag,	1 Stake Bag/ Stakes

Unroll and unfold the tent with the floor on the ground. Remove the fly and set it aside. Do not stake the tent down yet. In windy conditions, we recommend that a narrow end should face into the wind and that you stake down one corner of this end. See fig.1

Join the shock-corded poles together. Try to prevent pole sections from snapping together, as this can damage the pole ends. Make certain each insert end has seated firmly into each plain end.

CB

D fig. 3 A

Raise up the tent poles and attach the peak of the tent to them. Capture both poles where they cross, with the loop and dog bone. See fig. 4 & 5.

fig. 4

With the tent secure, drape the fly over the tent body. The fly only fits on the tent one way. Position the fly over the tent with the vestibule sections over the doors. Reach under the fly and connect the hook and loop tabs to the tent poles. See fig. 8.

Connect the four corner buckles on the fly to their mates on the tent webs. Do not fully tighten down any of the webs just yet. See fig 8.

fig.8 fig.9

C

B

A

fig. 5

At the front of the tent, pull the stake out loops on the vestibule taut and stake them down. Make sure that the vestibule is tight across the door. Repeat with the other vestibule at the rear of the tent. See fig. 10.

D fig. 1

At the front corner of the tent; [with the yellow web]- A, fit the post end of one of the aluminum poles into the web grommet. Angle the pole to the opposite corner; A to C.

At corner B, repeat with thefig. 2 second pole B to D.

Start at the front of the tent at D and grasp the end of the

pole in one hand and the web loop in the other. Push the pole from D to B creating an arc. Insert the post into the web grommet to tension the tent across the diagonal. Repeat with the other pole; C to A. See fig. 2 & 3.

Attach all the clips to the poles. Your tent is now free-standing, place it in location that has enough room for the fly and stake it down through the corner loops. Stake the opposite corners while applying tension to smooth the floor wrinkles. See fig. 6 & 7

fig. 6 fig. 7

fig.10

With the vestibule wing sections staked down and tight, go around the tent, and adjust or tighten all the side release buckles.

Your tent is now ready for use.

NOTE:

In strong winds, tie extra ropes to the storm loops on the fly and stake down so that the ropes are tight.

REV A 4.09