ASSEMBLY OF THE
TUNDRALINE TENT:
Component List:
1 Tent Body/Fly, 1 Carry Bag, 2 Poles, 1 Pole Bag, 1 Stake Bag w/Stakes, 8 Attached Guys w/sliders
Do not drop tent bag or pole bag on its end. Do not bounce tent bag on its end to get the tent out. These actions may cut the shock cord and/or damage the pole ends.
ASSEMBLY:
•Unpack the carry bag and separate all the parts. Unroll and unfold the tent and lay it on the ground with the black side down. If windy, place
A into the wind. Stake down the web loop at A.
See g. 1
A
g.1
•Assemble one half of a shockcorded pole. Try to prevent pole sections from snapping together, as this can damage the pole ends. Make certain each insert end has seated
firmly into its ferrule.
g.2
g.4
•Push the rest of the pole into the sleeve, assembling it as you work.
See g.4
•Repeat this with the second pole and sleeve at the other end of the tent .
•There is a locking post at each end
of the poles. Fit these posts into the web grommets at the sleeve ends to create an arch and maintain tension.
See g. 5 and 6
g.5
g.6
•At the side of the tent, stake out the web loops at each pole end. Work
your way around the tent, adjust the stakes, pulling the fabric taut to square the tent and remove oor wrinkles.
See g. 9
• This is a tension tent, therefore, do not depend upon staking alone to keep your tent upright and secure .
It’s IMPORTANT that you properly guy out this tent. See g.11
1.The Tundraline has 4 triangular guy lines, one at each corner attached to a pole sleeve. Pull out and stake these rst.
2.Next, pull out and stake the 2 guys that lead from the peak at each end.
3.Pull out and stake down the last 2 guy lines from the sidewall .
•If necessary, adjust the tension on
the vestibule webs to trim the roof. See g.10.
•Also, if necessary, move the sliders to adjust the tension on the guy lines to properly trim the tent walls.
See g.11 | g.10 |
YOUR TENT
IS READY!
• Slide the assembled pole half into the sleeve. Push the pole and pull the sleeve toward you, until the locking end tip pokes out from the opposite side.
See g. 2 and 3
g.3
•If not already staked, go to one end of the tent and drive a
stake through the web loop at the bottom of a vestibule.
See g. 7
• Move to the opposite end of the | g.7 |
tent. Grasp the vestibule web |
|
/loop and pull the tent fabric |
|
|
taut to raise the structure. This |
|
is not a freestanding tent. Therefore, you must stake out this web loop before | |
proceeding. | g.7 |
See g. 8
g.11
Take down: Open doors and pull up stakes. Pull posts out of the grommets. Remove the poles, collapse them and stow. Fold the tent into thirds. Lay the poles across the tent, roll up both towards a door and stow all.
REV. B 4.09
