Eureka 1950 How To Use, Assemble the Handle, Outer Bag, Bag Support, Attach Lower Cord Hook

HOW TO ASSEMBLE

F

C

A

B

A

Fig. 1

E

D

Step 1 - Assemble the Handle

Slip the upper handle and the lower handle together so the handle bolt holes align and the slots in the handle are positioned as shown in Fig. 1. Insert a 2-part bolt (A) in the

Step 4 - Outer Bag

Hold outer bag with zipper away from handle. Important: To provide a good gasket seal, the bag coupling must seat firmly against the motor base. Start the bag screws by hand, then tighten with a screwdriver.

Step 5 - Bag Support

Slip the ring at the top of the cloth bag over the bag support hook on the back of the cord hook.

HOW TO USE

The upright vacuum cleaner is designed to be used on multiple types of carpeting. Do not attempt to use the upright vacuum cleaner on bare floors, as damage to the floor covering may result.

center of the handle and tighten.

Hold the assembled handle so it curves away from the cleaner. Then push the handle into the handle socket (E) at the rear of the cleaner. Align the holes, insert the other 2-part bolt (A), and tighten.

Step 2 - Attach Lower Cord Hook
Insert the power cord into the lower cord hook
(B), as shown. Snap the hook into the lower
handle. Pull up on the cord to tighten but leave
enough slack near the base so the cord is not
strained when the handle is lowered.
Step 3 - Attach Upper Cord Hook
Pull the sleeve (F) on the electrical cord
upward toward the top of the handle. Make
sure slots in handle are positioned properly,
		BAG
Fig 1.
Insert the lower half of the sleeve (F) into	SUPPORT
the upper cord hook (C) as shown. Snap
the hook into the upper handle, directions
below.

Handle Adjustment

With the tip of the foot, press down to release the handle lock located at the left rear side of the cleaner. Move the handle and adjust it to the desired position for

(1)storing upright, (2) operating the cleaner at a comfortable height for the user, and (3) cleaning underneath low furniture.

Power Switch

The power switch is mounted on the motor hood near the handle. Switch style varies by model and may differ from the illustration. A push with the foot turns the motor ON; push again to turn the motor OFF.

1. Store

2. Use

3.Clean Underneath

Handle Lock

ON/OFF

1. Place inner	2. Press hook	3. SNAP opposite
tab into	around	inner tab into
slot	handle	place

Cord Storage

The cleaner has two convenient cord storage hooks attached to the handle.Wind the cord around the hooks for storage. Fasten the plug to the cord to prevent unwinding.

3