Eureka 3040 Series manual How to Maintain YourVacuum Cleaner, Maintain Brush Roll Part number

How to Maintain YourVacuum Cleaner

! Make sure vacuum cleaner is turned off and power cord is unplugged.

Maintain Brush Roll – Part number 77315

Do not remove end caps. Remove hair and threads from brush roll periodically.

Replace EXT-U Belt if Worn,cut or Out of Shape – Part number 61120C

! Motor can become hot with normal use.

Avoid touching the motor shaft when checking brush roll belt.

1)Use handle release to lower handle flat onto floor (Fig. 1).

Remove Brush Roll Cover

1)Remove 2 screws from the front side of brush roll cover (Fig. 2).

2)Lift and remove brush roll cover (Fig. 3).

Replace EXT-U Belt

1)Remove brush roll and belt.

2)Thread new belt around motor shaft and brush roll (Fig. 4).

Replace Brush Roll

1)Insert left end of brush roll first. Make sure square on brush roll cap is in place.

2)Pull right side of brush roll to stretch belt.

3)Secure right end cap into base (Fig. 5).

4)Rotate brush roll 2 turns to center belt.

5)Replace brush roll cover and two screws (Fig. 6).

Fig. 1

Fig. 3

Fig. 5

Fig. 2

Fig. 4

Fig. 6

Change Light Bulb – Available on some models – Part number 57940-3

!Make sure vacuum is turned off and power cord is unplugged.

1)Pull up release handle latch and remove dust cup compartment.

2)Unscrew the lens cover and remove old bulb (Fig. 7).

3)Push in new bulb, replace lens cover and screw. (Fig. 8).

4)Replace dust cup compartment, snap release handle down to secure.

Fig. 7

Fig. 8

4Eureka Customer Service HELPLINE 1-800-282-2886

www.eureka.com