Cyclonic Bag Saver (on some models) continued
Fig. 2a
Fig. 2b
Tab &
Slot
Handle
Fig. 3
AX
MAX
Attaching the Cyclonic Bag Saver onto the vacuum cleaner
Your vacuum cleaner is equipped with two wands.
Fig. 2a Push the hose nozzle into the top of the cyclonic housing until it is firmly in place.
Fig. 2b Attach the cyclonic dust cup onto the cyclonic housing. Place the slot in the cyclonic dust cup over the tab on the cyclonic housing. Then grasp the handle on the cyclonic dust cup, and pivot the cyclonic dust cup up and over the ledge on the cyclonic housing.
Fig. 3 Push the nozzle at the bottom of the cyclone unit into the top of one of the straight wands. Adjust the position of the cyclone unit. Install the last straight wand and then push the assembled wands into the floor tool.
Important Safety Information
-Do not vacuum surfaces which have been subjected to inflammable solvents.
-Do not pick up any liquid.
-Do not pick up hot ashes which could cause a fire.
Emptying
Empty the dust compartment of the cassette after each use or when the dust cup is filled up to the MAX level, Fig. 3. Detach the dust cup by following the instructions in Fig. 2b in reverse.
Empty the contents into a waste container. To reattach the dust cup again follow the described steps in Fig. 2b.
Maintenance
The Cyclonic Bag Saver can be washed in cold or warm water and a mild detergent. Thoroughly dry the dust compartment with a soft towel before using it again. If the cyclone unit clogs, use the vacuum cleaner to unclog it.
7