Eureka 4700 manual How to Maintain YourVacuum Cleaner, Maintain brush roll

How to Maintain YourVacuum Cleaner

! Make sure vacuum cleaner is turned off and power cord is unplugged

Maintain brush roll

Motor can become hot with normal use.

Do not remove end caps. Remove hair and threads from brush roll periodically.

Check U belt. Replace if worn, cut or out of shape

! Avoid touching the motor shaft when checking brush roll or belt.

How to replace brush roll or belt

1) Use handle release to lower handle flat onto floor (Fig. 1).

2) Remove 2 screws from the front side of brush roll cover (Fig. 2).

3) Lift and remove brush roll cover (Fig. 3). Fig. 1

Fig. 2

4)Remove brush roll and belt. Thread new belt around motor shaft and right end of brush roll (Fig. 4).

5)Pull right side of brush roll to stretch belt. Secure right end cap into base (Fig. 5). Align left end cap with square in base and push into place.

6)Rotate brush roll 2 turns to center belt. (Fig. 6).

7)Replace brush roll cover and 2 screws (Fig. 2).

Fig. 3

Fig. 5

Fig. 4

Fig. 6

Change light bulb (on some models)

! Make sure vacuum is turned off and power cord is unplugged.

1)Lower handle to floor and remove HEPA filter (Fig. 7).

2)Unscrew the lens and remove old bulb. Replace with bulb rated 12v., 10w., Type 904.

3)Push in new bulb, replace lens cover and replace screw (Fig. 8).

4)Replace HEPA filter and cover; return to upright position.

Fig. 7

Fig. 8

4Eureka Customer Service HELPLINE 1-800-282-2886

www.eureka.com