Eureka 5180 warranty Thermal Cut Off

HOW TO USE THE SELF-PROPELLED VACUUM CLEANER (continued)

How to Adjust the Cleaner Height Setting

WARNING: Avoid injury. Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts (such as the revolving brush roll and power drive wheel). Turn off the switch and unplug the electrical cord before changing the cleaner height setting.

1.Turn off the switch and unplug the electrical cord before changing the cleaner height setting. If you need to adjust the cleaner height setting to the next position, place the handle in the operating position. Rotate the height adjustment knob to the next position. This will make the cleaner easier to push.

2.Plug the electrical cord into an outlet.

3.Position the power switch to the on position, place the handle selector button to the self-propelled position and begin to vacuum.

When finished cleaning, return handle grip selector button to manual position and place handle upright.

On/Off	3
(I/O)	2

Handle Release

Height Adjustment Knob

Store or Use

Attachments

Use

Clean Under

Handle ReleaseFurniture,

Beds, etc.

1

Thermal Cut Off

This cleaner has a special thermostat that protects the cleaner in case of motor overheating. If the cleaner suddenly turns off, follow this procedure:

1.Push on/off rocker switch to “OFF” position.

2.Unplug cleaner.

3.Check for source of overheating problem (i.e. full bag, clogged hose or clogged filter).

4.If a full bag, clogged hose or clogged filter is found, replace the bag, unclog the hose or replace the filters.

5.Wait at least 30 minutes before attempting to reuse the cleaner.

6.After 30 minute cool down period, plug the cleaner in and push the rocker switch to on position. The cleaner should turn on.

7.If the cleaner still does not operate, take it to any Eureka Authorized Service Center for repair.

7