Eureka 5190 Series warranty HOW to Assemble Vacuum Cleaner Handle

HOW TO ASSEMBLE VACUUM CLEANER HANDLE

CAUTION: Moving parts, make sure on/off switch is in off position before plugging in.

Upper Handle

STEP 3
CAUTION: Do not pinch the	Lower
transmission cable between
	Handle
the upper and lower handle.

Lift the upper handle and place it over the lower handle.

Line the holes up (one on each side of the lower handle). The transmission cable should stay in place in the lower handle tube during assembly.

STEP 1

Pull the foam protector pieces from the ends of the handle and throw away.

STEP 2

Find the 2-part bolt in the plastic bag with the owner’s guide. It is the only part needed to assemble the vacuum cleaner handle. See below.

2-Part Bolt

Transmission

CableFlexible

Hose

STEP 4

Move flexible hose off hose hook to allow easier access to the handle area.

While the holes in the handle are lined up, put the 2-part bolt in the holes and use a flat blade screwdriver to tighten securely.

The handle is now installed. The vacuum is now fully assembled and ready for use.

5