PERIODIC MAINTENANCE (CONTINUED)
Brush Roll
The brush roll turns as it sweeps and combs the carpet nap. Remove hair and threads from the brush roll so it continues brushing the carpet. To maintain the most efficient cleaning, the bristles must touch the carpet. To test the bristle length, hold a ruler against the underneath side of the cleaner. If the bristles no longer touch the ruler, replace the brush roll.
5
Brush Roll Belt, Style U
The brush roll belt turns the brush roll to agitate, sweep, |
| |
and comb the carpet nap. Check the belt regularly to be |
| |
sure it is in good condition. Replace the belt if it stretches, | 5. Place new belt around motor shaft. | |
cracks or loses tension. Cut away any hair or threads wound | ||
| ||
around the brush roll or the belt pulley because the buildup |
| |
could cause the belt to rotate unevenly. |
|
How To Replace Brush Roll Belt
NOTE: | Turn off the switch and unplug the |
| electrical cord before replacing belt. Belt |
| pulleys can become hot during normal use. |
| To prevent injury, avoid touching the motor |
| shaft when changing the belt. |
1
2
2
2
2
1.Lower handle to floor to change belt.
2.Remove three screws indicated by screwdrivers in above illustration. Lift hood to remove.
NOTE: The carpet height adjustment has to be in the lowest or highest position to remove or reinstall the hood.
4
Motor
Shaft
Belt
Brush
Roll
3
3.Lift left end of brush roll.
4.Remove and discard belt.
6
7
8
6.Place belt around brush roll pulley.
7.Align left end cap with base. Push end cap securely into place.
8.Pull right side of brush roll to stretch belt. Secure rightend cap into base.
9
IMPORTANT
9.Rotate brush roll by hand two full rotations to properly position belt.
10.Place hood back on cleaner. Make sure hood front is behind furniture guard. Replace three screws.
11.Tighten screws.
Use GENUINE EUREKA replacement belt, Style U. Look for the GENUINE EUREKA product symbol.
8
