Eureka 5740-5799, 5840-5898 warranty To Clear Blockages in Hose

To Clear Blockages in Hose

NOTE:Turn off the switch and unplug the electrical cord before clearing hose.

Nested

Wands

Hose

Adapter

Tabs

1Locate upper hose adapter on the back of the cleaner.

2Remove nested wands from back of cleaner for easy access to hose adapter tabs.

3Press hose adapter tabs together and pull hose adapter away from cleaner. The hose adapter will unscrew off hose for easy access to debris if necessary.

4Check for blockages at cleaner opening and in hose. If no blockage is found, continue to step 5. If blockage is found, clear and continue to step 11.

Lower

Hose

Adapter

Base

Hose

5Locate lower hose adapter on the back of the cleaner. Remove lower hose adapter from rear of cleaner by lifting

6up and twisting.

7Check for blockages in the hose and base hose. Flexing the hose may help loosen any blockage. If no blockage is found, continue to step 8. If blockage is found, clear and continue to step 11.

	s	PROBLEM
8	Remove hood from cleaner and check for a	SOLVING
	blockage in the brush roll area. Make sure the
10	hose inlet is clear.	Clear
	Place lower hose adapter back into the base hose.
9	After the blockage is found and cleared, replace
	the hood on the cleaner.	Hose
11	Install the upper hose adapter onto the back of
	the cleaner, line it up with the cleaner opening
	and push it against the cleaner until both tabs

15