Step 2 |
|
Attach Lower Cord Hook |
|
Make sure cord hook is pointing |
|
downwards. Press the power cord | 2 |
into the groove on the cord hook | |
pulling any slack toward the base of |
|
the cleaner. On the cord hook, find |
|
the curved tab and place in slot on |
|
lower handle section, keep cord taut |
|
while pressing the cord hook to the |
|
left until it snaps into slot on opposite |
|
side of handle. The hook should |
|
point downward on the same side |
|
that the cord exits the hood. |
|
Step 3 |
|
Attach Outer Bag |
|
Important: To provide a good |
|
gasket seal, the bag coupling | 2 |
must seat firmly against the motor |
|
base. |
|
Hold outer bag with zipper away from the handle. Line up screw holes. Start the bag screws by hand, then tighten with a screwdriver.
Loop the bag spring onto the bag support hook located at the back of the upper handle section.
Step 4
Store Electrical Cord
The cleaner has two convenient cord storage hooks attached to the handle. However, some models feature a quick release cord hook on the upper handle. A downward twist of the cord hook frees the cord for quick removal. With either style, wind the cord around the hooks for storage. Fasten the plug to the cord to prevent unwinding.
6
3 |
3 |
4 |
4 |