Eureka 6820 Identify Parts Of Cleaner, Assembly, How To Use, Open the Slip, Ring to reduce

IDENTIFY PARTS OF CLEANER

2 7 1 3

3a

4

5

1. Cord Rewind Pedal. 6

2.On/Off Pedal.

3.Bag Indicator (on some models)

3a. Tool Cover Latch

4.Hose Inlet

5.Bag Cover Latch (on top of bag cover)

6.Carrying Handle (on the bottom)

7.Variable Speed Control (on some models)

8 9

10

8.Exhaust Filter

9.Motor Filter (behind dust bag)

10.Disposable Dust Bag

11

11. Electric Cord

ASSEMBLY

	Open the Slip
1	Ring to reduce
	suction.

1 Attach wands and cleaning tools

Slip the circular end of an accessory tool onto the end of the hose handle and twist slightly to secure. If additional reach is needed, place a wand on the hose handle first.

3

1

Combination

Floor Tool

24

2Pull electric plug out from back of cleaner push plug into outlet. To rewind, step on Cordaway cord reel button, hold and guide plug while it rewinds.

NOTE: When pulling on electric cord watch for a yellow line on the cord. Then continue slowly pulling on cord till you see the red line, stop. The red line indicates the end of usable cord.

HOW TO USE

A carpet should be cleaned regularly over heavily traveled areas, and once a week over the entire carpeted area. Vacuum slowly, making several passes (forward and back- ward) over the carpet, covering small areas at a time. The time required to clean the carpet will depend on several factors–including type of carpet and amount of dirt.

3Push ON/OFF Pedal

(A thermostat automatically shuts the motor off if it overheats, see Automatic Motor Shut-Off)

4Adjust brush height to high for bare floors (brushes in down position) or low for carpets (brushes in up position).

3