Brush Roll
The rotating brush roll sweeps and combs the carpet nap. Keep the brush roll free from hair and threads so it will continue brushing. When the bristles of the brush roll no longer touch a piece of cardboard held across the bottom plate, the brush roll is ineffective because the bristles no longer touch the carpet nap. To maintain the most effective cleaning, the brush roll should be replaced with a new one.
Brush Roll Belt and Light Bulb
The brush roll belt on the motorized nozzle drives the brush roll to agitate, sweep, and comb the carpet nap. The belt should be checked regularly to be sure that it is in good condition. Replace the belt if it is stretching, cracking, or slipping. Cut away any hair or thread wound around the brush roll or belt pulley because the buildup could cause the belt to rotate unevenly.
How to Replace Worn Belt or Light Bulb
Note: Turn off the switch and unplug the electrical cord before replacing belt or bulb. Pulleys can become hot during normal use. To prevent injury, avoid touching the pulleys when servicing the drive belt.
1. | Remove four screws from bottom |
| |||
| side. Turn unit over; pull up on hood |
| |||
| to remove. |
|
|
| |
| Replace light bulb, if necessary. |
| |||
| Use GENUINE EUREKA 15 watt |
| |||
| replacement bulb, 48815. |
| |||
| Continue to step 2 to change belt. |
| |||
| Skip to step 7 to replace hood. | { | |||
2. | Lift out brush roll and discard used | ||||
| |||||
| belt. |
|
|
| |
3. | Put new belt around brush roll pulley |
| |||
| first; then the motor pulley. |
| |||
4. | Place left end cap into the base. |
| |||
5. | Pull right end down to seat end cap. |
| |||
6. | Rotate brush roll 1/2 turn to make |
| |||
| sure belt is |
| |||
| brush roll pulley. |
|
| ||
7. | Position hood; secure with screws |
| |||
| (see Item 1 above). |
|
| ||
|
|
|
|
| |
Look for the | GENUINE | symbol. |
| ||
EUREKA PRODUCT |
| ||||
|
|
Use GENUINE EUREKA replacement belt, 58065.
{ | { |
{
Motor Pulley
{
{
Brush Roll Pulley
13