Eureka 96 manual HOW to Assemble, HOW to USE, Charge the Batteries, Power Switch

ENGLISH

●I

	HOW TO ASSEMBLE (continued)
● ●	Charge the Batteries
	Note: Charge the batteries for 14-16 hours before
J K
	initial use. A cleaner may lose charge in
	shipment. The charger plug will become warm,
●	however, this is not a cause for concern.
O	Note: If the batteries are completely void of charge, the
	charging light may not shine until there is
	sufficient charge in the batteries to provide power.
FIG. 5	O
	Step 1: Turn the nozzle ● down and lower the cleaner onto
	I
	the bracket ● (Fig. 5) or remove the battery from
	the cleaner and place battery in charging stand.
	J	K
	Step 2: When the charge light ● or ● lights up it
N	indicates that the battery in the unit and/or an
	extra battery is charging.
●
Off	It is all right to leave the cleaner on constant charge so it
Floors
	is always ready to use. Unplug only if it will not be in use
Carpets
	for several weeks at a time.
	Note: You can charge a battery in the unit and an extra
	battery (optional) at the same time.

	HOW TO USE
FIG. 6	Power Switch
	Note: On initial use, the clear plastic shipping switch
	lock must be removed to activate the switch.
	Pull on tab to remove.
	N
	Step 1: Push the power switch ● down to turn on; push
	up to turn off.
G	Step 2: Select type of cleaning. Carpet cleaning starts the
●	brush roll turning. Bare floor cleaning stops the
	brush roll (Fig. 6).
M	Step 3: To use on bare floors or area rugs, make sure that
●
	G
	handle ● is attached to the cleaner body (Fig. 7).
	G
	Step 4: To use as a handvac remove handle ● by
	M
	releasing the lock button ● (Fig. 8).

FIG. 7

10 FIG. 8