GETTING TO KNOW YOUR CANISTER VACUUM
1. | On/Off Button | 8. | Easy Glide Rear Wheel |
2. | Handle | 9. | Extension Tubes (x2) |
3. | Cord Rewind Button | 10. | Carpet / Floor Brush |
4. | Full Bag Indicator | 11. | Dust Bags (x2) |
5. | Cover | 12. | Flexible Hose |
6. | Cover Locking Tab | 13. | Manual Suction Control |
7.Air Intake Duct
Technical Specifications
Voltage: | 120V., 60Hz. |
Power: | 10 Amps |
Illustrations may differ from actual product.
2
TROUBLE SHOOTING GUIDE
TROUBLESHOOTING GUIDE
PROBLEM |
| POSSIBLE REASON | POSSIBLE SOLUTION | ||
|
|
| 1. | Check for blockage - remove it. | |
| 1. | Hose, wand or inlet is | 2. | If dust bag is full, replace dust | |
Motor runs but no |
| blocked. |
| bag or look for blockages in | |
2. | Check bag full indicator. |
| system or vacuum. | ||
suction |
| ||||
3. | Hose clamp not assembled to | 3. | Insert hose clamp into hose inlet | ||
| |||||
|
| hose inlet properly. |
| until "snap" locks for proper | |
|
|
|
| assembly. | |
|
|
|
|
| |
|
|
| 1. | Pull cord out, straighten and | |
Cord does not | 1. | Cord twisted. |
| rewind again. | |
2. | Cord pulled out too far - | 2. | Holding the plug, press the | ||
rewind | |||||
| beyond "RED" mark. |
| rewind button and try to rewind | ||
|
|
| |||
|
|
|
| again. | |
|
|
|
|
| |
| 1. | Not firmly plugged in. | 1. | Plug unit in firmly. | |
Cleaner won't run | 2. | Blown fuse/tripped breaker. | 2. | Replace fuse/reset breaker. | |
3. | Motor thermostat may have | 3. | Allow unit to cool down before | ||
| |||||
|
| tripped. |
| trying to switch "ON" again. | |
|
|
|
|
| |
ORDERING REPLACEMENT FILTERS & BAGS
TO ORDER REPLACEMENT FILTERS & BAGS
OR FOR TECHNICAL SUPPORT
FOR MODEL CV520HB/HR/HY
Call: | 1 (800) |
Monday to Friday 8:30 A.M. - 5:00 P.M. Eastern Standard Time
IMPORTANT: DO NOT ATTEMPT TO WASH or REUSE DUST BAGS.
Always replace with new dust bag to keep your unit in maximum working condition.
Please Note:
The
7
