OPERATING INSTRUCTIONS

Even if you have used a steam generator iron before, please read all instructions and safeguards in the Use and Care Instruction Book. In addition, please note the following user tips:

USING STEAM

PLEASE NOTE: Steam performance improves after the first 6-8 hours of usage. The steam power increases and initial condensation at maximum temperature is reduced.

1.Make sure the temperature setting of the iron is within the steam range on the temperature selector.

2.Turn power on for iron and steam generator. Before starting to use steam, make sure the Steam Ready Light is ON”, indicating that steam is available.

NOTE: Trying to use steam before the Steam Ready Light is “ON” can cause water drops in the steam coming out of the iron.

CLEARING THE INITIAL CONDENSATION:

3.Clear the initial condensation by pressing the Steam Button up to 3 seconds. Repeat if necessary.

IMPORTANT NOTE:

4.While using the ironing system, if steam has not been released for more than approximately 5 minutes, the hose has cooled and any steam remaining in the hose from the last use might condense. Clear this condensation by pressing Steam Button before proceeding to use the iron.

CLEANING & MAINTENANCE

CAUTION! NEVER open the boiler filler cap before ALL the remaining steam has been released from the steam generator and the steam generator has cooled. To release the steam, press the On/Off button to the “Off” position and push the steam button on the iron until no more steam comes out of the iron. Then open the boiler filler cap slowly.

1.We strongly recommend the use of demineralized/distilled water to ensure optimum performance and maximize the life of your steam generator. If you are using demineralized/distilled water, the steam generator should be cleaned once every six (6) to twelve (12) months. If you use regular tap water, the steam generator should be cleaned once a month.

2.Make sure that all the steam has been released from the steam generator before doing any cleaning or maintenance on the appliance. Follow instructions on page 7 for releasing the steam.

3.Remove the power cord from the electrical outlet and let the unit cool down for at least 4 hours after it has been used before starting to clean the steam generator.

4.NEVER immerse the iron or the steam generator in water or any other liquid.

CLEANING THE STEAM

GENERATOR BASE

1.Make sure that there is no steam remaining in the steam generator.

2.Make sure that the steam generator is completely cold.

3.Remove the boiler filler cap by slowly turning counter clockwise to allow any remaining steam to escape.

4.Fill water tank with a solution of 20% vinegar and 80% water (5 oz vinegar and 21 oz of water) and let sit overnight (8-12 hours).

5.Replace the boiler filler cap and shake.

6.Remove the boiler filler cap and empty the tank. Rinse with water two to three times by filling, shaking and

emptying again.

6.Wipe the outside of the steam generator base with a damp cloth.

CLEANING THE STEAM

GENERATOR IRON

1.Clean the steam generator iron ONLY when cold.

2.Do NOT use scouring pads, abrasives or harsh cleansers.

3.Use a commercially sold soleplate cleanser following the manufacturers label instructions.

4.Use a soft damp cloth to wipe the outer shell of the iron.

5.Dry soleplate and iron thoroughly after cleaning.

STORING YOUR STEAM

GENERATOR IRON

1.Ensure that the seam generator is depressurized by opening the steam button on the iron until no further steam is escaping.

2.Always unplug the power cord from the electrical outlet when not in use.

3.Always store in a dry place away from the reach of children.

4.Always drain the water tank before storing.

5.Always let your steam generator cool completely before storing.

6.Do not let power cord and steam hose to touch hot surfaces.

7.Wrap the power cord and steam hose around the appliance loosely.

3

8

Page 4
Image 4
Euro-Pro G6118 owner manual Using Steam, Operating Instructions