Euro-Pro GI495E owner manual Atomizer Spray Nozzle, Selecting Iron Temperatures

OPERATING INSTRUCTIONS

OPERATING INSTRUCTIONS

4. Place the iron on its heel on a stable,

protected surface and allow the iron

to heat for approximately two (2)

minutes or until the temperature

settings on the right side of the LED

display panel have stopped flashing.

5. Turn the variable steam control dial

to the right to increase the amount of

steam. When using extra steam, the

iron uses more water and it may be

necessary to fill the water tank more

often. (Fig. 2)

Fig. 3

ATOMIZER SPRAY NOZZLE
The atomizer spray nozzle is useful on
fabrics with stubborn wrinkles. Press the
spray button and a jet of water will spray
onto the fabric being ironed. (Fig. 5) The	Temp.
water spray can be used with dry or
	settings
steam ironing as desired.

Fig. 2

BURST OF STEAM/X-TENDED STEAM BURSTTM BUTTON CAUTION! DO NOT aim iron at face, towards yourself, or anyone else while using or adjusting steam. Burns or serious injury may occur.

The burst of steam position is useful when ironing denim, cotton, and linens. It provides quick bursts of steam which aid in removing stubborn wrinkles.

The burst of steam feature can be used with Dry or Steam ironing as desired.

1.Make sure the water tank is at least 1/2 filled with water.

2.Select the desired fabric and temperature setting. Place the iron on its heel (on a stable, protected surface) and allow it to heat for approximately 2 minutes.

3.Turn the steam button to the left to the burst of steam position. (Fig. 3)

4.With the iron in a horizontal position, press the steam button several times to prime the pump.

NOTE: If the tank runs dry, remove the plug from wall outlet. Then, fill the iron with water and re-prime the pump. The iron may be filled with water while it is hot.

To use the X-Tended Steam BurstTM feature:

1.Set the variable steam control dial to the desired steam setting.

2.Press the electronic temperature control button until you get to the desired fabric setting.

3.Turn the steam button clockwise to the X-Tended steam position. (Fig. 4)

4.To maintain a constant flow of steam, make sure that the water tank is at least half full.

X-Tended

Steam Burst

Fig. 4

Fig. 5

SELECTING IRON TEMPERATURES

Always read garment labels and follow the manufacturer’s ironing instructions. Refer to the “Ironing Chart” on page 9 for temperature recommendations:

•Use low settings for nylon and other synthetics.

••Use moderate settings for wool, silks, and blends.

•••Use high settings for cottons and linens.

1.Stand the iron upright on its heel.

2.Plug the cord into a polarized, 120V AC electrical outlet.

3.Press the electronic temperature control until you get the desired fabric/temperature setting.

4.The light on the right side of the LED display panel will stop flashing when the desired temperature has been reached. (Fig. 6)

Fig. 6

ATTACHING THE EXTRA

LARGE SOLEPLATE

WARNING! Use caution when attaching the soleplate to the iron.. Burns may occur from touching hot metal surfaces, hot water or steam.

1.Lift the soleplate clamp and place the iron on the soleplate making sure that the heel of the iron is fitted into the two retaining tabs on the back of the extra large soleplate.

2.Lower the nose of the iron and close the soleplate clamp to secure the iron in place. (Fig. 7)

g in in ta s e b R ta

Fig. 7

5

6