Operating Instructions
Removal of Battery Pack
1.Turn unit over so that the base is facing upwards. Be careful not to turn the unit ON.
2.Push in locking tab and lift off the battery compartment cover. (Fig. 3)
Operating Instructions
How To Operate Your Cordless Sweeper
1.Before using, please ensure that the cordless sweeper has been initially charged for 20 hours. Your cordless sweeper will only operate properly when the batteries are fully charged. Your sweeper will operate for varying lengths of time on a full charge. This will depend upon the type of surface being cleaned (longer operating time on bare floors vs. carpets).
2.Push the On/Off switch to operate the unit. To turn off, press switch again. (Fig. 5)
Locking Tab
Fig. 3
Battery Pack
Compartment Cover
On/Off Button |
3.Carefully lift out the battery pack and disconnect the wire terminals by pulling apart the wire terminal connector. Remove the battery pack from the unit. (Fig. 4)
Wire Terminal Connector
Fig. 4
4.Connect the wire terminal connector from the unit to the wire terminal connector of the new battery pack, and replace the battery pack into the unit. Replace the cover and press until it snaps in place.
5.Follow instructions for initial battery charging. Please call customer service at 1 (800)
DO NOT ATTEMPT TO REPLACE THE BATTERIES USED IN THIS PRODUCT WITH ANY OTHER TYPE OF BATTERY.
Important: This appliance contains
6
Fig. 5
3.To release the handle to a comfortable position, gently apply pressure to the top of the sweeper head with your foot while pulling back on the handle. (Fig. 6)
Fig. 6
7