![](/images/new-backgrounds/1150365/15036515x1.webp)
18."INPUT 1 ~ INPUT 10" Inputs
These ten balanced/unbalanced combination type jack (XLR and 6.3mm) input, Meant for the connection
| 2 | 1 |
|
| 3 |
Balanced microphone | ||
| 2 | 1 |
|
| 3 |
Unbalanced microphone |
Balanced microphone | Stereo jack |
|
Unbalanced microphone | Mono jack |
|
Note
Connecting unbalance microphones to the appliance when the phantom is switched on could lead to severe damage on the microphones and is therefore not permissible. It is absolutely mandatory to perform any plugging or unplugging of microphone cables with the phantom power turned off. Also make sure that the phantom power is turned off when utilizing microphones that are not meant to be operated with phantom power, The voltage that is present on pin2 and pin3 of the
19."INPUT 1 ~ INPUT 10" Inputs sensitivity and XLR phantom 24V switch
By turning this switches onto the "LINE" position the input can be connected to an audio source with high level signal output. By turning these switches onto the "MIC" position, the input can be connected to a dynamic microphone with low impedance. By turning these switch onto "24V"
position, connects the 24V phantom supply on XLR of pin2 and pin3 of inputs, necessary to operate condenser type microphone which require this type of external supply. It is recommended to use this switch with the general volume set on minimum.
7
20. Input sensitivity switch (AUX1 , AUX2)
By turning switch onto the "1" position, the "AUX 1" , "AUX 2" input suitable for connected to CD player signal output. By turning this switch onto the "2" position, the "AUX1","AUX2" input suitable for connected to AM/FM radio signal output. By turning this switch onto the"3" position, the "AUX1" "AUX2" input suitable for connected to desktop cassette player signal output. By turning this switch onto the "4" position, the "AUX1", "AUX2" input suitable for connected to
21. TEL. Paging input level control
This control let you set the volume of the sound source that is connected to the "Tel. Paging" (23) turning control clockwise can increase the volume of the corresponding source. We recommend to leave the control at it's minimum setting "0" when it is not used.
22. LINE OUTPUT CONNECTOR
This XLR output mixed audio signals of all sources that can be utilized to feed an external power amplifier or an other external appliance.
23. Input "TEL.Paging"
It lets you connect to an auxiliary signal (600 ohms). The input features the "Voice Priority" function
,which overrides all other input signals, once an auxiliary message is sent. If you want to have this function disabled forever, please contact an EV SERVICE CENTER.
24."Priority" terminal
When
1W / 8 Priority | Aux. Paging | |
- | + | T R G |
Auxiliary conctat
25. Output terminal for auxiliary loudspeaker
The terminal is meant for the connection of a small external loudspeaker that gets driven by an internal auxiliary power amplifier, providing a nominal output 1 watt. Only the mixed audio signal coming from "AUX1" , "AUX2" "CASSETTE" and "TUNER" are included in the output signal. In addition, the output signal is controlled only by the volume controls of the "AUX1","AUX2","TUNTER" and music signal level control(4). This function is toggle switch the "MONITOR OUTPUT"(4) additional loudspeaker.
1W / 8 Priority | Aux. Paging | |
- | + | T R G |
+
1W 8 ohm
26.DC switch
This switch lets you turn the battery supply on or off.
8