EverFocus ED120 Series instruction manual IV. Specifications, Wall Mount, aim to left

4)Wall Mount, aim to left:

Remove the iron case from the supporting bracket by using screw driver to loosen the two screws, which connect the iron case to the supporting bracket. Turn the iron case

in 90-degree and mount into the supporting bracket again by changing the screw holes in order to keep the screw indicator on the top side.

qConnect the video output of the camera (yellow line) to a B/W monitor (ED120) or a color monitor (ED200), or other video device through a 75 ohm type coaxial cable with BNC female connector at cable extension.

rConnect the DC+12V regulated power source of the camera (red line) to the DC12V Power-in jack with 2mm, center+, outer- plug.

sConnect the ground of the camera (black line) to the ground.

tConnect the audio output of the camera (white line) for EM120 to the audio connector of the monitor.

uPut the plastic cover back on the Dome Camera.

IV. Specifications

		ED120	ED200
Pickup Device:	1/3 inch B/W interline		1/3 inch Color
	transfer CCD		interline transfer CCD
Picture Element:	510 x 492 (EIA)		510 x 492 (NTSC)
	500 x 580 (CCIR)		500 x 580 (PAL)
Horizontal resolution:	420 TV lines (EIA)		380 TV lines (NTSC)
	400 TV lines (CCIR)		340 TV lines (PAL)
Sensitivity:	0.04 lux/F=2.0		2.5 lux/F=2.0
S/N ratio:	Over 48 dB		Over 48dB
Electronic shutter:	Up to 1/100,000		Up to 1/100,000
Gamma Correction:	> 0.45		0.45
Video output:	1.0Vp-p,75 ohm		1.0Vp-p,75 ohm
Audio Output:	Yes		---
Power source:	12VDC+/-10%,		12VDC+/-10%,
	150mA Max.		250mA Max.
Sync. Mode:	Internal Sync.		Internal Sync.
Lens Mount:	M12 x P0.5		M12 x P0.5
Dimension:	106mm Dia x 85mm H.		106mm Dia x 85mm H.
Operating Temperature:	-10oC to +50o C		-10oC to +50o C

ED120 Series

ED200 Series

INSTRUCTION

MANUAL