VD/DD (Auto Iris lens Type)
For video drive auto iris lens, please set switch to VD. For direct drive iris lens, set switch to DD. The default setting is DD. Wire the cable of lens to lens connector according to the following table.
| Pin1 |
| Pin2 |
| Pin3 |
| Pin4 | Lens Connector | ||||||||
Video Drive | +12V |
| GND |
| GND |
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
| ||||||
|
| 1 |
|
|
|
|
| 3 | ||||||||
|
|
|
|
|
|
| ||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
| ||||
Direct Drive | Cnt- |
| Cnt+ |
| Drv+ | Drv- | 2 |
|
|
|
|
| 4 | |||
|
|
|
| |||||||||||||
|
|
|
| |||||||||||||
|
|
|
|
| ||||||||||||
|
|
|
|
|
|
|
|
|
|
| ||||||
6.IRIS Level Control
Brightness Level can be adjusted from the IRIS level VR while using the direct drive lens.
??Turn counterclockwise to L to get darker picture.
??Turn clockwise to H to get brighter picture.
7.V-Phase Adjustment Screw
The vertical phase may require adjustment to synchronize the vertical phase of the camera with other camera in the system when it is to be used in the
8.Mounting Base and Fixing Screws
To use when the mounting bracket is required while mounting the camera. The mounting base can be attached to either the top or the bottom of the camera, fix the mounting base onto the camera by using the 4 supplied fixing screws.
9.Video Output Connector BNC VBS 1.0 Vp-p, 75ohm
10.Audio Out Connector
11.Power Cable (EQ150)
12.DC12V/AC24V Screw Terminals (EQ150A)
7
