12
and Advanced setup. Basic setup interface mainly includes network access mode, IP
address, subnet mask, gateway address and other parameters, as shown below:
【Connect mode】：with two types of static IP and dynamic IP. IP address, gateway
address and subnet mask should be entered
manually for the static IP. Dynamic IP is the IP
allocated by DHCP server.
【NTP Server】：Set the time and correct the
server address to achieve the time
synchronization of DVR.
【HTTP Port】：For IE brower connecting ,enter
the URL http://192.168.1.220:8000.
【Media Port】：The port number adopted when there is private protocol between DVR
and
PC end. When ex-factory, the DVR has a default value. If this port is occupied by other
Services , modify it to an unused port.
【Intercom port】: the intercom function for remote device and the DVR
Note: The range of above ports is between 1024 and 65535. the ports can not be the
same.
2.7.2 Advanced
【Sub stream】：Set image quality and frame speed. When the network is not good, the
secondary stream can reduce the image quality and frame rate and open by default.
【Email】：Support email alarm when an event is triggered, DVR system will
automatically intercept the pictures when an event is triggered and then send it to the
specified mailbox to prompt the users. For specific setup procedures, please refer to the
detailed operation in the CD.
【DNS】：Set the IP of DNS server's
【Mobile】：Set the mobilephone service port
【UPNP】: When the UPNP is on (the UPNP at the Router is also on), the DVR host will
map the port and IP automatically to the Router.
Note: If the Router doesn’t support UPNP, please manually map the corresponding port