Everpure EV9797-21 manual Kleensteam II Single System

EV9797-21

Kleensteam II Single System

Everpure's second generation of total water treatment system for steam applications

	B E N E F I T S
	A total system delivering high quality filtered
	water with scale inhibition and deliming
	capabilities
	New dual cartridge design provides enhanced
	performance for low or high flow capacity
	steamers and flexibility for expanding to meet
	future needs
	Fine filters incoming water to improve the
	performance, maximize energy efficiency and
	increase the life of steam equipment
	Reduces chlorine-induced corrosion
	System is simple to install, operate and maintain
	Easy deliming with ScaleKleen, which is fed into
Kleensteam II Single System: EV9797-21	the boiler through the SR-X bowl without use
	of hazardous chemicals or special piping
7CB5 Replacement Cartridge: EV9618-11	Long lasting SS-10 cartridge is more effective in
	higher alkalinty/hardness/TDS/temperature
SS-10 Cartridge: EV9799-02	installations
	Sophisticated Hydroblend compound prevents
	limescale formation in high temperature steam
	applications

I N S T A L L A T I O N T I P S	O P E R A T I O N T I P S	A P P L I C A T I O N / S I Z I N G
Choose a mounting location suitable to support	Change 7CB5 cartridge on a regular 6 month	For commercial steam applications
the full weight of the system when operating	preventative maintenance program, when capacity
	is reached or when pressure falls below 10 psi	For use with foodservice steamer and combi-oven
Use minimum 1/2” inlet water line (3/4”		applications
preferred)	Change SS-10 cartridge before Hydroblend™
	compound is completely used up	The Kleensteam II Single System is shipped with
Connect the system to the boiler feed water line		one 7CB5 cartridge (for first filter head) and one
only! Do not connect to the condenser water line!	Service flow rate must not exceed 2.5 gpm for	filter head plug installed in the second filter head.
	single cartridge systems or 5.0 for dual cartridge	Capacity is expandable by adding a second 7CB5
Install vertically with cartridges hanging down	systems	cartridge.
Allow 2-1/2” clearance below the cartridge for	Always flush the filter cartridge at time of
easy cartridge replacement	installation and cartridge change
Flush cartridges by running water through filter	Use for periodic deliming as needed by installing
for five minutes at full flow	the dip tube assembly in place of the SS-10 and
	dissolving Scale Kleen in SR-X housing. Full
	deliming instructions are provided with the
	system