CARL EDWARDSRACING HANDHELD
TABLE OF CONTENTS
Installing Batteries 3
Functions of Buttons 5
How to Play 6
Tips 6
Special Care & Handling 7
Battery Information 8
FCC Warning 9
90-Day Limited Warranty 10
3
Congratulations on your purchase of the Nascar®
Carl Edwards Racing Handheld from Excalibur
Electronics, Inc. Carl Edwards Racing Handheld is
easy to carry and easy to play. Bring it everywhere
you go and enjoy hours of fun. You’re going to love
playing with your Speedway Racing handheld.
Carl Edwards Racing Handheld is easy to use, but
be sure to use it safely. Before starting, please read
this manual thoroughly, especially noting safety, care
and battery information. Keep this manual for refer-
ence.
This package contains Carl Edwards Racing
Handheld and its manual.
NASCAR®is a registered trademark of The National
Association for Stock Car Auto Racing, Inc. Carl Edwards®name
and likeness areused with permission from ROUSCH RACING®.
ROUSCH RACING®and Carl Edwards®are registered trade-
marks of Rousch Racing, Inc. of Livonia, MI.
The legendary King Arthur brandished a magic sword,
Excalibur, from which we take our company name.
With this unique weapon in his hand, he
could not be vanquished.
Although Excalibur Electronics can’t
claim the magical secrets of Merlin,
King Arthur’s court wizard,
sometimes our patented technology
may make it seem as if we could.
We make you think.
2

Installing Batteries

Your Carl Edwards Racing Handheld requires
2AAA batteries. Be sure to review “Battery
Information” on page 8. To install batteries, carefully
turn Nascar’s®Carl Edwards Racing Handheld over
so that the top-side is face-down on a soft surface,
such as a towel or magazine. You’ll find the battery
compartment on the unit’s back.
Use a small Phillips screwdriver to remove the
screw. Lift off the battery compartment lid. Install
2AAA batteries, making sure to match the polarity
(+ and -) with the diagram inside the battery compart-
ment. Place the battery compartment lid’s tabs in their
slots and snap the compartment door back on. Replace
the screw and gently tighten it.