Userʼs Manual for

Do It Yourself Workbench

DO IT YOURSELF WORKBENCH PIECES

The Do It Yourself Workbench has 49 pieces. 41 pieces are used to put together the Do It Yourself Workbench

BATTERY INSTALLATION & INFORMATION

The Do It Yourself Workbench drill requires 2 AA batteries, not included. Using a Phillips screwdriver,

remove the battery cover from the drill and insert the batteries as shown. Make sure to match the polarity. Replace the battery cover securely.

Batteries should be installed and replaced only by an adult.

Do not mix alkaline, standard (carbon- zinc) or rechargeable (nickel-cadmium) batteries.

Do not mix old and new batteries.

Do not use rechargeable batteries.

Remove exhausted batteries from the unit.

Do not short circuit battery terminals.

Remove batteries and store them in a cool, dry place when not in use.

To avoid explosion or leakage, do not dispose of batteries in a fire or attempt to recharge alkaline or other non-rechargeable batteries.

Use only batteries of the same type and equivalency.

DO IT YOURSELF WORKBENCH SET-UP

Page 1
Image 1
Excalibur electronic EI-PT1013 manual Do It Yourself Workbench, Do IT Yourself Workbench Pieces