45
SET UP101-In-1 Action Games Plug and Play
The Infrared (IR) receiver
should go on top of the TV so
that it receives a clear signal
from the controller units. Use
the stick pad on the bottom of
the receiver to stick it firmly in
place. Remove the protective
layer from the stick pad and
then press the receiver firmly
down onto your TV.
Take the RCAcables (these
are the white and yellow
plugs) and plug them into the
corresponding slots on the
back (or sometimes front) of
your TV. Lay the battery
housing on a flat surface and
you have completed
connecting the 101-In-1Action
Games Plug and Play
system.
Turn on your TV and flip the
on/off switch on the battery
housing to the ON position.
You should see the game’s
start-up screen. With the
controllers pointed at the IR
receiver,flip the controller
switch to the ON position and
you are ready to select a
game.
Note:
Some television sets
require that you set your TV to an
auxiliary video channel. This
channel may be referred to by the
following names: Video, Source,
Game, AUX or Input
Quick Set Up:
1. Follow the instructions for installing batteries.
2. Remove stick pad from IR sensor and firlmly press it to the top of your TV.
3. Connect the yellow and white RCAcables into the corresponding plugs on your TV.
4. Turn on your TV and flip the switch on the battery housing to the ON position
5. Turn on the controller units and you are ready to play!
BATTERYINSTALLATIONBattery Housing
Carefully open the casing on
the battery housing. This is
done by using the tab on the
side of the unit. Once open,
install 4 AAbatteries into the
unit, making sure to match the
polarity of each battery as
shown in the diagram inside
the battery compartment.
Once complete, firmly close
the battery compartment.
Controllers
Gently lay the controllers face
down. Underneath is the
battery compartment. With a
small Phillips head screw
driver, unscrew the battery
compartment housing. Insert 4
AA batteries (each controller),
making sure to match the
polarities as indicated on the
inside of the battery
compartment. Replace the
cover and screw on tightly.
Infrared Receiver
Battery Housing